SIZES ( IN INCHES ) Diameter -Bolt of cutter Thickness of cutter. It should last a long time!ĮDIT: Just took a look at the Microjig site - that's really funny as they're basically demoing all the stuff I'm trying to do! Unfortunately their clamps aren't the quick clamp type though, just the screw-downs. T - slot cutters ( With Brown & Sharpe taper shank ) These cutters are. T-Slots - High Speed Steel - For Non-Ferrous & Cast Iron. High Speed Steel - Extended Length T-Slot Cutter. The aggressive flute geometry helps aid in chip clearance. They have alternating right and left axial rake. Since it has worked so well I will probably use it on my upcoming workbench and assembly tables (from Timothy wilmots system workshop) for which I will use hard maple. T-Slots are typically used to cut a T shape in an existing slot. I think the bigger issue is how long the edge will last if it's being constantly abused by sliding clamps. I clamped the maple down as hard as I could and didn't hear any telltale cracking - since stock is being clamped flat to the surface it prevents the clamp from having too much pull upwards. Even on this cheap junk it holds very, very strong. I clamped a piece of 5/4 hard maple, lined it up against the fence, and ripped a perfect 1.5mm strip off the right side of it (the jig is meant to act like a sliding table on the left side of the to your point, consider that the clamp is using the whole length of itself, not just a point load.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |